Just run what I ran and make 600whp and top off your oil every once in a while. I ran those specs because that is what I read from others and it...
https://www.tascaparts.com/ and I used this site to look at diagrams...
I sold the car forever ago but when I had it they seemed to work well without any issues. I can't say they will last longer than any others.
I used the ARP bolt for this very reason. It is not TTY and can be removed and used again. It has tq specs that for me were just easier. It was...
As long as the timing tool fits and everything else is correct I am sure it is fine.
I also have a thread on timing if that helps. Usually the more info the better....
They used epoxy on my pads and I never had any issues. I believe this is what they used. [MEDIA] Loctite EA E-20HP (29314) Toughened High-Strength...
I used the motorad one for a few years without any issues, maybe yours was faulty?
lol Yes, as long as the roads are good we can tune it but would likely need to touch it up again when it is balls hot out.
Regulators that support carb and FI do a poor job at both. I had an aerormotive and the return orifice is too large so it would surge if you set...
Don't forget to shake the bottles well before dumping, the additives like to settle.
[ATTACH] Your adblock probably blocked the link, mine does that on this site too.
Yes, works great. I used it when I had a leak on a trans pan. It kept it sealed for a few years until I replaced the gasket.
[MEDIA] This stuff works great. Could be a fix.
https://www.youtube.com/shorts/qKR2-DFrda4
Good to hear on the car, sorry to hear about Mom. Hoping for a speedy recovery, if you need anything we are here for you.
Looks great. Excited to see more.
I think I just did like 2 lbs past what CS said.
I don't have any more pics, the lip in the bowl is all I really cleaned up.
Finally
Separate names with a comma.