X-rings require a little finesse when installing so they don't get twisted or torn, unlike round profile o-rings that are a bit more forgiving. If...
Glad to hear they all worked well for you. I double checked my Drive folders and since it's been over a year since I sold my MS3, I seemed to...
I have no idea, you'd have to look into whether it's comparable with what Mazda uses. Unfortunately, the Asian manufacturers don't use published...
Great write up, thanks. I noticed the same build up of pressure the last two times I had to remove the fluid and wondered why the vent wasn't...
I've got all the manuals as well so if it comes to that I should be in good shape. Since it still capable of moving on its own I stabbed the axle...
Well, not encouraging findings. Pulled the axle and no apparent damage other than the hole in the boot. Drained the rest of the fluid, no chunks....
I had a few mins last night and drained out part if the trans, no bits, a good sign. I reinspected the inner boot, stretching and pulling to see...
Before I drain the trans I'll have to try the wet grass trick, I don't wish to cause any more damage than I've already done. I massaged both...
So, something went bang yesterday when I launched on my final run of the day. I chalked it up to things possibly moving around despite the mounts...
So, the Flennor and others that cross reference to that P/N compare to OEM measurements as shown below. Dimensions are center to center of the...
They aren't specifically for coil overs, more for lowered cars in general. I ran them for a short time before I fabricated adjustable links. I...
Here's a few of the more recent parts I've purchased with good or better results. Toyota oil filter 90915-YZZD3 (mfg by Denso). For the...
I'm at the end of the line for now. I have managed to move the subframe as much as possible to resolve my camber issue, unfortunately I wasn't...
Since this is now somewhat of a diary in my quest to even out the camber available and gain as much caster as possible, I have made yet another...
Update..... Following the body shop debacle that lasted a month, weighing the car and getting it back on an alignment rack I have some feedback...
Following a slight run in with a Lexus RX300h and it's daft owner it'll be a bit before I get a chance to corner balance the car and align it....
Once everything is loosened up the rear slides back and forth easily so no twisting unless you set it that way. Screw idea came from Zenit on the...
Fixed, I didn't figure it mattered much.
I can track down before specs but no after specs yet, I need to replace the inner tie rods (nuts seized) and can't adjust toe. I should have taken...
Here's some camber adjustment info that may be helpful. I found an alternative camber plate setup from Silver Project while seeking more camber...
Separate names with a comma.