3D printed pieces were just done to try out the design. If/when they go to production, they will be machined aluminum. As you mentioned, it would be faster. Pretty cool that you have that printing capability, though.
Keep me in mind if you want or need something done. I can provide a quick turnaround for you and Matt. Plus, it's a great excuse to meet up with you. Haven't seen you guys in a while. Sent from my iPhone using Tapatalk
What is the tubing spec on this? I forgot to grab one on my way out, gotta get it today. What kind is it outside diameter? Sent from my SM-G930T using Tapatalk
So don't just spit on it and pound it in, you want some KY. Got it. Sent from my SM-G930T using Tapatalk
Can't wait to see how this pans out. I have been putting off valve cleaning, but this could spark my interest in finally getting off my ass.
How do you know about this? I always assumed that with your handsome physique you were able to ruin panties by just taking your shirt off.
Got the pipe to penetrate the hole to shoot media. I'll probably use tape to seal it up. Sent from my SM-G930T using Tapatalk
@Raider will give more feedback on these. No success story for us today. Couldn't get enough vacuum through the plastic holes. The walnut media filled up the valves too quickly. We had faster results without it. Someone else should try these and see if it works better for them.
I think I know what the problem may be, you didn't cup the balls when sucking. crapatalk it sucks for free
Lies! I cupped AND fondled. Don't accuse me of such amateur mistakes again, you heathen! Now where is my crack pipe, I might need to suck, blow, and fondle again.
It worked decently for me, I think what it boils down too is your vacuum setup. I also think it may have been more beneficial for the ports to be stacked instead of side by side.
Vacuum was our problem. I think bigger holes would have made the vacuum better, but would have made blasting messy. Essentially defeating the point of the plate anyway. What was your blaster set up like?
My vacuum set up is a 2.5 maybe 3? Hp shopvac (I believe that's at the wheels too) with a 2 1/2 inch hose with an adaptor that fed it down to a tube that was the perfect size for the port on the plate.