Brought tears to my eyes.. My usual owner of tire shop in our closest small town always took care of me, great BS talker too. Well he had his 17...
Can't say either of my stock or 340 hp 3's have that issue. Now if you ask about my vw rabbit first year usa model and a rebuild with dodge omni...
Zip ties in a figure 8 pattern work well too. Really cheap and frustrating until you figure out the origami.
Yes the divorced waste gate pipe the smaller of the two in the old style can cause issues with wastegate control if you are running a larger...
Speed Performance has done 2 sets of mine. Not cheap, but if a injector fails disappointing. So out of 8 and 3 were bad. Now while it's a crap...
Best to create a thread for your specific trouble. Then it's easier for others to help, future searches if a cure is found to help the next...
I should mention that after I was running the S3.....for about 500 miles enjoying the boost. The old tired 140k motor leak down numbers went bad,...
When I bought a S3 they recommended a oil line/filter....
Home Depot sleigh runs?
I agree, I should mention... I am the only driver...Backseat passenger not a fun ride in mine. Mine has CF hood, rear hatch and fiberglass rear...
Thank you for the update/feedback on your fix. Please think about a custom tune. You will never think the money was a waste after the results.
Welcome to this great community. I will happily watch your story unfold!
Well.... I'm a old man 66 with a typical back that lived a hard life. So since I still have a stone stock 08 speed 3 let's just say, it's much...
https://mazdaspeeds.org/index.php?threads/pjb-not-a-sandwich-here-is-whats-inside.11901/ I opened up the PJB to show a wire I had installed. Clam...
https://mazdaspeeds.org/index.php?threads/bilstein-b16-pss9-ms3-07-install.11808/ Here somewhere I have before and after 4 corner height measurements.
A surprise I found was a very old likely installed just bought from Mazda.. wires were spliced into loom harness left side under dash. Followed...
I had it on that turbo when I exchanged it between two different 6's. Look at your favorite turbo web site and look at water block to turbo center...
In my case. I had a sneak current draw too. My 07 speed 3 was a Bose system. I also did circuit by circuit check of PJB and it was interior common...
Passenger Junction Block is (at least my 07 & 08) behind and below the glove box. The fuses you are looking at feed the PJB. Metal Membership is a...
Glad to hear you found a problem part. Make sure since the fault and evidence of failure means high currents were involved. Things that melt are...
Separate names with a comma.