fixed it, CP-E catted downpipe, cat was plugged. gutted it and welded on new flex pipe. spools awesome again
Hi guys, finally ran into a problem with my speed 6 it was tuned for 26psi of boost and now i hit around 11-12. i went through the basic...
Yes sir. my only concern was the small battery i put in because of the intake. no problems though starts right up.
i use mine as a daily drives perfect. 4032 mahle foged pistons, manley H beam rods, balancer delete, CST4 turbo PD tuned.
not familiar with those, i used Mahle pistons and had no issues with the Gen1 squirters
if you're gonna do it. do it right. i would not use stock pistons with forged h beam rods, i would have to add the forged pistons.
sound like carbon fouled oil control rings.
thanks guys.. i did hear back from Will he suggested methanol injection would be best. the ~450whp was just a guess. if not doable. then just max...
hey guys, i just finished up tuning with Purple Drank. car is running great. i feel like i'm going to get tired quick of the power though. i'm...
your not going to make 450whp on a stock turbo and that small intake. next concern would be the health of the block. my goal was around 350whp.....
if the engine is stock i'll put money on the oil rings being carboned up. i was using a quart in 500 miles or so.. compression was good. pulled...
i'm running a 21mm top and 24mm 2nd ring gap. this is mostly for the amount of boost you want to run this setup is good for over 21psi 3k on the...
the machinist will know what's best. if the bores are round and not damaged you can hone, otherwise over bore.
if you are breaking down the motor... especially with a rod knock, you might as well have the entire block machined. there are way too many tools...
i need these for mine, it runs and now it's quick enough to realize the brakes could use some work. too bad i just dropped a bunch of $$ on a...
i just went through this with a CX racing intercooler. i changed the core for a Treadstone TR8 and now my BAT's are better. methanol install this...
i snipped away about a 1/4" on both holes of the gasket. if you line it up on the downpipe you'll get a good visual of what needs to be done.
i have the 2.5" magnaflow cat back with a 3" CPE downpipe. the catback was on the car when i bought it. i added the downpipe. i bought a gasket...
Thanks for the support. hoping to have more videos soon. i have a new issue :)
okay guys, i installed the TR8 i did not have to modify the crash bar at all. it bolted right on to the CX racing couplers and it's butted up to...
Separate names with a comma.