Okay, I will check them out if I go that route. Hopefully it's a simple fix.
I'll check out the manifold tonight to see if I need a new one. I will hit you up if I do. If the VTCS is broken, would it be easier to just...
I got off the phone with him a little while ago. He's very unwilling to assist me with any of the issues stating "he doesn't push out projects...
I connected the boost leak test to the intake side. I used the How To on MSF. I used an air compressor and was able to push in 15 lbs, according...
Well I ordered some new studs and locking nuts from Edge last night. I did install a new 3.5 inch intake recently, but the MAF has been calibrated...
Well the bpv wasn't the issue. Replaced the gasket today. Still not able to build boost. I can build boost around 6500 rpm. But anything before...
I haven't taken my bpv off recently... That I can think of.. But if it has been off for some time now, it wouldn't make sense because I just...
[ATTACH] This car will be the death of me. It's becoming a trail of fail each day. I am positive I have a boost leak, and the only culprit I could...
I'm not very mechanically inclined and I managed to do both of the above-mentioned. Unless you just lack the space to do them... that's another...
I thought about doing that as well. What are you using to mount it there?
I completely agree. Will any amount of tape assist in protecting it? Just in case? I have a 51R battery in the stock box right now... I'm thinking...
No, I only have a RMM at the moment. I'm ordering a TMM next paycheck. That half inch doesn't seem to be a whole lot, but it's better than it...
Okay thanks! I was concerned about the MAF as well. So I readjusted some things and now it looks good. About a half inch space between them.
Will mounting my ecu like this cause any issues?
I'll get it checked out and post my findings. Maybe it just has a harsh bite that I'm not used to. Maybe it's not slipping as much uing...
This is my second ACT... I don't recall the first one doing it. Is there a possibility they installed they disc uncentered? Or possibly didn't...
I'm good on the break in... I'm still doing minor pulls while the engine breaks in as well... But I dont think it's normal for it to shake the...
So, just got a new long block installed and also installed a new clutch at the same time. The 'reputable' mechanic that I used is starting to...
Money, mainly. Blew the K04 and the engine basically at the same time... so funds were tight. CS turbo was a nice swap without having to change...
Well, it wasn't the tune... It was seriously the smallest damn thing and I'm a little upset they didn't notice it. They forgot to attach a ground...
Separate names with a comma.