Recent Content by PandaMS3

  1. PandaMS3
    Post

    PandaMS3

    Sweet thanks! I’ll send him a message!
    Post by: PandaMS3, Jan 22, 2024 in forum: Mazdaspeed 3 Build Diaries
  2. PandaMS3
    Post

    PandaMS3

    Thanks! Where would you recommend I source the motor? Jegs has a reman for 3600. But that is a bit outta budget
    Post by: PandaMS3, Jan 21, 2024 in forum: Mazdaspeed 3 Build Diaries
  3. PandaMS3
    Thread

    PandaMS3

    So it finally happened. My daily driver speed had an engine failure. Rings aligned on cylinder 1. At 176k of hard driving the baby finally had...
    Thread by: PandaMS3, Jan 20, 2024, 4 replies, in forum: Mazdaspeed 3 Build Diaries
  4. PandaMS3
    Post

    Building Anna

    Nice headers. DTP?
    Post by: PandaMS3, Oct 10, 2022 in forum: Mazdaspeed 3 Build Diaries
  5. PandaMS3
    Post

    Help An Old Broken Down Tuner

    Nah I wasn’t saying you don’t belong, I’m just impressed that your self tuning a supercharged cx5
    Post by: PandaMS3, Oct 3, 2022 in forum: VersaTune
  6. PandaMS3
    Post

    Help An Old Broken Down Tuner

    This is all being done on a CX5?
    Post by: PandaMS3, Oct 3, 2022 in forum: VersaTune
  7. PandaMS3
    Post

    Hello

    Agreed. This forum is a fountain of knowledge that will often save a LOT of time and money
    Post by: PandaMS3, Oct 2, 2022 in forum: New Member Introduction Section
  8. PandaMS3
    Post

    Hello

    Welcome to hell, here’s your pitchfork
    Post by: PandaMS3, Oct 2, 2022 in forum: New Member Introduction Section
  9. PandaMS3
    Post

    RWD 1st Gen

    so the smaller holes bolt directly?
    Post by: PandaMS3, Sep 22, 2022 in forum: Mazdaspeed 3 Transmission/Drivetrain
  10. PandaMS3
    Post

    RWD 1st Gen

    You’re beautiful thank you
    Post by: PandaMS3, Sep 22, 2022 in forum: Mazdaspeed 3 Transmission/Drivetrain
  11. PandaMS3
    Post

    RWD 1st Gen

    When I do the rear I have to widen the track by at least .5” to fit the RS sub. Might as well go 2” wider right? Go wide or go home The...
    Post by: PandaMS3, Sep 17, 2022 in forum: Mazdaspeed 3 Transmission/Drivetrain
  12. PandaMS3
    Post

    RWD 1st Gen

    Purpose built road course and hopefully still kinda street legal. I am going to tube at least the lower, cut out the rear floor pan, drop the fuel...
    Post by: PandaMS3, Sep 17, 2022 in forum: Mazdaspeed 3 Transmission/Drivetrain