lean at wot

Discussion in 'Mazdaspeed 3/6 ECU Tuning' started by CounterKilla, Apr 14, 2020.

Watchers:
2 users.
  1. CounterKilla

    CounterKilla Greenie Member

    Joined:
    Apr 1, 2020
    Posts:
    18
    Trophy Points:
    3
    Location:
    new jersey
    Ratings:
    +1 / -0
    Hey it's me, back again. I fixed my issue by buying an oem maf sensor. Car is pulling VERY well and feels fine. Im currently on the versantune 93 base map for a downpipe. I did some logs just to be sure everything is good and this is what i see. 13s at wot... a little bit of knock at the end too. It begins to taper into the 11s where it should but before that is what im worried about.
     

    Attached Files:

  2. JohnnyTightlips

    JohnnyTightlips Motorhead Silver Member

    Joined:
    May 12, 2016
    Posts:
    1,557
    Trophy Points:
    113
    Location:
    Iowa
    Ratings:
    +2,454 / -3
    https://www.revisionsrus.com/logs/1337

    The log shows you not going WOT, you need to keep the pedal all the way to the floor for a full wot log. STFT and LTFT are doing their job as you are not going actual WOT. App would be 99, throttle would be 76 if you were actually WOT. To get a good log you will want to put the gas all the way to the floor at 2800 rpm and hold it there until at least 6500 unless it starts bucking or cutting out.
     
  3. CounterKilla

    CounterKilla Greenie Member

    Joined:
    Apr 1, 2020
    Posts:
    18
    Trophy Points:
    3
    Location:
    new jersey
    Ratings:
    +1 / -0
    are those acceptable numbers for the throttle position then? should i be worried or no
     
  4. JohnnyTightlips

    JohnnyTightlips Motorhead Silver Member

    Joined:
    May 12, 2016
    Posts:
    1,557
    Trophy Points:
    113
    Location:
    Iowa
    Ratings:
    +2,454 / -3
    If you were actually flooring it than no it's not reading correctly. If you were pussy footing it than that's what the log is showing.
     
    Last edited: Apr 15, 2020
    JohnnyTightlips, via a mobile device, Apr 14, 2020
    #4
    • Like Like x 2
Loading...

Share This Page

Users Viewing Thread (Users: 0, Guests: 0)