Recent content by Ahmed Bahgat

Sure, I can convert them to PDF, I will try again Cheers This document has all the parts inside the gearbox grouped by shafts, prices are also included This document shows all the parts I have bought from both USA and Australia for my project of changing the diff

I can email you the documents if you wish, they are very useful and without the one with all parts for all shafts with prices I would not be able to find the parts I needed Cheers

I did not get the option to download doc file, just the zip file but I will try again later today Cheers

Hello Been very busy, I have the word document with all the parts I bought from mazda-parts,com, I will try to upload it The most impotrant tool is a 20 Ton press, I got for 200 AU$, along with 2 and 3 legs pullers, however, I can put also the full list of tools that I needed for the job, but...

Yes, but I tried everything and just makes it quiet it a bit, but it stays, also the old LSD was rattling, in fact one of the side pinions is completely loose Friction modifies are bad, I think, for the synchros Cheers

Hello all I finally managed to put an end to the dreadful woo woo noise when you have the steering wheel full turn on very low speeds The cause is known, it is coming from the LSD which uses clutch pack to differentiate the front axle left and right wheels speed, the clutch pack get worn after...

Thanks for the reply mate I managed to get one from a CV specialist shop who took it off a new shaft and installed it on my vehicle drive shaft and he even declined to charge me. very nice Cheers

Hello mates I had to remove the left drive shaft in my Mazdaspeed 3 Gen 1, and in the process of removing it, I damaged the dust protector metal ring that covers the transaxle left oil seal. It seems I cannot find it anywhere other than buying a whole new left drive shaft, so my question is, is...

Hello mates Hope everyone is safe and well. I am re-installing the reverse light and neutral position switches to my gearbox, when I removed the two switches there was some sort of green sillicon or thread locker on both threads of the switches, the service manual says install both switches...

Thanks mate. I expected so. You will not be able to get the seal with the tool anymore, I am trying to buy the tool from Ford for about A$130.00, expensive but I have no other option. Cheers

Hello mates I am sorry I need to revive this thread as I am having the same issue, I bought the seal from Mazda in the USA despite I live in Australia, and it came without the alignment tool, I was told it does not come with the alignment tool anymore, however without the alignment tool and...