Recent content by Awines2326

Alright I think I'm finished all the way around. Now, it's gotta go to the machine shop for new guides and a valve job for these new supertech valves

Exhaust side is 90% complete! Finish up the last little polish touch-up and I can be done with that side!

Starting to feel a lot better about the exhaust side now. I think I'm actually done removing material now. Think this should allow more total volume while keeping up velocity. Hopefully keeping ideal backpressure when I try running big boost!

Still have quite a bit to do on this head, but I've made some major progress!

Got my new 6 puck ACT disk, and have been waiting on the Xtreme pressure plate to show up for a while now. Finally came in, and turns out I have the old style prolite flywheel, so it won't fit. Now I've gotta order a new flywheel to get the clutch back together... Good news is I've had some...

Are you upgrading to stiffer springs? If not I doubt there is a reason to change them. Leakdown test to determine if the seals would be necessary as well. Intake valve cleaning and injector cleaning make a massive difference. And if you fail the leak down test I would suggest cleaning the valves...

Supertech valves arrived today! Went +1mm Exhaust in Iconel and std size intake black nitride. Didn't feel like the iconel was necessary on the intake side hopefully I'm right! Also pulled my clutch and got a Gen2 transmission with 100k miles. Should eliminate my 2nd gear pop-out and give me...

Still not done with porting this head, but all the major material removal is complete. Pictures attached next to an oem head. Need to finish the center of the runners by hand and put a polish on everything so it's slippery smooth! Kelford 84lb springs and titanium retainers showed up today...

Yeah I actually replaced the full clutch line with a braided stainless line and bled it fully as well. I also do run DOT4 and try to exchange a chunk of it from the entire system every year. I'm wondering if I just didn't do a great job of bleeding the clutch line, or conversely I did a really...

So i got the car to start up and went for less than a 5 mile drive, used the brakes liberally and they felt good. I've been bleeding them with a hand pump and finally with the pedal for 2 days. They initially had a drop after and I threw a splash of fluid in. Mid drive the ABS light shut off...

The only light I'm getting is a solid ABS, my check engine flashes but nothing else I noticed. I connected FORSCAN and all the normal codes are there EGR VCTS, and 1 ABS for my steering wheel sensor being disconnected. It's always been a CEL and never popped the ABS light. The speed isn't...

Been doing a bunch of work to my car, finally got it all together and I have an ABS light on, I assume from changing all 4 calipers and the car recognizing ABS needs to be bled. But the issue is after I shut the car off it won't start back up unless I unhook the ECU and plug it back in. It...

Freektune FTW pistons are in and look glorious! Now I just need some 12mm head studs so I can send all this stuff off to the machinist!

Kelford C-2 cams showed up! The pieces are all starting to come together!

Managed to install the CS exhaust manifold, looks solid but that sucker is waaaaaay heavier than my Tubular manifold! Got my new brake calipers and threw some super hard high head caliper epoxy on them so they don't end up as corroded as the originals... Also got my TB Performance front and...