Recent content by dbh86

Just installed my set. Took a bit of time, but worked out well... mostly. I ended up dropping the whole rear subframe to do all the rears and the differential mounts at the same time. HOWEVER, 4-06-19621 does not fit the 2007 MS6 front LCA inboard bushing, and they do not make one for this...

Ended up swapping in a used motor to see where that would get me. 500 miles in and have oil pressure issues. Got home last night and the oil pressure light was flickering at idle. Running a 5w30. Tested the pressure hot: 10 psi at idle, 42 psi @3000 rpm (spec is 43...) Have a few questions...

Lurked on the other forum for a while but never was looking to do anything to my 6 as it is(was) my DD. Never did anything to it performance wise, on my 2nd VVT actuator:(. Have had issues with oil burn for the last few years and oil smoke under extended idle (cold or hot). Oil light started...