Recent content by JT020110

I did one of these on my 6 not too hard of a job and turned out decent. https://www.eastdetailing.com/collections/mazda Sent from my iPhone using Tapatalk

Thanks!!

My first how to, been years since I have posted anything this long on a forum lol. Anywho. This is a hopefully a simple how to with lots of pictures to swap Gen 1 sport seats into a MS6 GT (minus seat heaters - I live in az) Final fitment - they sit maybe 1-2 inches higher than original if...

Reys Mazda Parts on FB sells HPFP rebuild kit for like 35 bucks, the X-ring inside helps prevent fuel dilution in your oil.

If i had a welder I would have used the exact design above, its nice and simple. Since i don't have a welder I have used 2'' square metal tubing for this bracket and it actually keeps a nice flat horizontal line up to the linkage. i used the measurements in that drawing to drill holes to reach...

Excited to see the results!

very nice man

What spoiler is that bud - looks amazing

good to know from what I read I thought that the pump lines just needed to be as close as level or below bulkhead. I wonder if I can drop it down more..

thanks I like those are nice and would make the lines shorter too - I left quite a bit there so it wouldn't pull the connection points but just lays all up in the bumper lol

So I was messing around with the idea of using the oem tank for meth but house it on the drivers side. And it actually fits as well as the pump. What I really wanted to achieve after seeing a lot of installs before I bought one was to have as short amount of injection line as possible. I didn't...

So I finished this setup last week, just wanted to share. made out of 3/4'' MDF board Kicker 600.1 Kicker 250.4 JL 10w1v2 Dimensions for .52XX cubic feet of airspace 28 L 13.5 H 4.5 D I used brads and wood glue then sealed the inside with standard silicone. stuffed with batting to account for...