Recent content by keefover

217 switch on ;) I finally got around to reading your thread. It was great seeing you at the BBQ as well.

I've seen your car for sale on CL forever now. You can sell a Speed 3 down here to save your life. I practaly had to give my Gen Pu away to get anyone to bite.

Ohhh hiiiiii

I'm actually located in New Orleans now @Raider hence the thread title ;) Good looking out though.

Hell no. I still haven't closed on the building. I am in the process of selling some real estate in SD to fund it. That should close end of next week. As soon as it does I can close out here. Then I have about a shit load of work to do to make it a decent place to work out of.

I am going to wait to get that vendor status. Should only need a couple more posts.

What's up man? I need to get my post count up so I can PM. Where is all the action on this forum?

Hate to bump an old thread but I have personally measured distortion in excess of .0015 in on a block honed with out a torque plate after installation of a torqu plate L19's torqued to 75ft/lbs. I would say mitigating that distortion by final honing with the torque plate installed and torqued...

Hello, I had joined up when the site went live a while ago but have failed to be active. This is my official "hello" thread. :raisinghand: