Recent content by L337TurboZ

Nice

How bad were the compression numbers? Did you get ripped off by the guy? It sucks you're in that position. Would you really just move on to a different platform?

I still say BMW simply because of the ability to run the absolute dog shit out of them with just bolt ons. For example my M6 with just intakes, downpipes and a Stage 2 tune puts down around 700 wheel horsepower (granted im V8 twin turbo) Only major thing I needed to do? Upgrade my rod bearings...

How far from the border are you? What if you buy it in the US and then just pick it up instead of having it shipped to you directly?

I say get a BMW. An older 3 series or 5 series and race that. You'll go RWD but spare engines can be had for cheap plus they'll handle well. By older I mean you can get a 2012-2016 340i for less than 10k and its an inline 6 turbo. Do the crank hub upgrade and you'll be good to go. It sucks you...

I am not 100 percent positive but in the future you might be able to use newer Yukon/Suburban air ride shocks in the rear. Theyre heavier duty due to the increased size of the SUVs

Why not do the PPV swap? He would never get pulled over and people would move out of his way on the roads.

It needs a Pro Guard and some police package wheels

You'll just need to buy an MPVI3 device and a few credits. You might need 2 or 3 credits to unlock everything on the Tahoe. The minimum is 2 but sometimes you also have to unlock the Fuel Pump Control Module/Chassis Control Module. The software VCM Editor is free and so is VCI Scanner. Make...

You can disable the DoD system through the computer and ideally install non DoD lifters. However just turning the system off in the ECU drops the failure percentage by at least 80 to 90 percent. I disabled mine with just the computer and never had any problems. The issue comes down to when the...

Did you end up buying it?

Did you end up buying the Tahoe? I highly recommend getting HPTuners right away and disabling DoD and tuning the 6L80. There are a lot of small improvements that can be had by just doing those. I used software called BC Trans to adjust the tables for mine. Pretty easy to use. I can also email...

I had put a gen 2 in it originally. I dont remember the odometer reading. Like I said I sold it about 3 to 4 years ago. I think it was around 160k? Maybe 170k. Whoever bought it just dogged the crap out of it and treated it like crap. I had that car for a few years. Daily driven. I took it...

I sold the car with the access port. ALL the mods minus the painted valve cover and intake manifold were done by me. The clutch however may have been replaced. I did put a single mass lightweight flywheel and ACT clutch in it originally. The guy local to me who got it from the Navy kid had been...

Wouldn't have to deal with rust if you bought my Suburban...lol