Recent content by pizzarolls

@Gizmo and @Raider, all i know at this point is that the motor has to get stripped down and that there isn't a hole in the side of the block. based on the rpm's going nuts, I'm assuming that it is the rod bearing but we ran it a few times trying to figure it out so i'm hoping no additional...

So, pretty sure I threw a rod bearing on Friday. After a pull going from top of 4th to about 5k in 5th, my RPM's started hanging and not returning to normal. If I was to let off throttle completely at say 4k, it would stay at 4k for about 5 seconds, drop, and bounce. Pulled over to the side of...