Recent content by Pyrannha

Check your wiring, chase that power wire to the PCM. That's a circuit low code so usually no power or bad connection. Was the code there before the 3 port swap?

She’s done! Found out a lot of things along the way. Darton dry sleeves (part number 300-052) were the answer to the piston/cylinder issues. After that the only thing I had to do was get a set of oversized crank bearings since the crank had also been shaved which took a bit of doing. Got the...

Just came here to say that i just did this job myself and this guide is spot on, though there's a few workarounds if you want to. I pulled the caliper and rotor, removed the lower ball joint and the outer tie rod end and got the axle out with only that detached and the knuckle still attached to...

Looking at it, that seems like it might be a great option. I'm going to reach out to them and make sure that will work on this block but I really like that idea.

Thought I’d post an update as a handful of things have happened – most of them not good. So firstly the delay – car got in an accident. Traffic stopped and the guy behind me didn’t and gave me a good ol shove into the guy in front of me. No insurance of course but I’m insured. 6500 dollars of...

Starter relay shoudl be ground until powered by the pcm for start signal I do believe. As far as your P2507 code, first step is test the battery and clean or replace the terminals. I can't really tell from your picture but they don't look super shiny and new, I'd do that first. Form there the...

Not sure if this is going to be a real build dairy or if it’s going to just say what I’ve done and ask a few questions and hope for some info. Probably more the latter Anyhow. I picked up my 2012 back in 2014 with about 30k miles on it. It’s now got 175k and boy, have there been many proverbial...

Well, new to this forum anyway. I've had my 12 Speed3 since 2015, bought it with about 30k miles on it and it's now got 175k. There's things to change, work to be done and mods to make as well as work that has been done and mods that have been made. I'll probably post in the builds section at...