Recent content by RCP1990

also, for the bottom two holes, one is present on the focus st and the other is present on the NC miata oilpan. I havent looked at my MS6s pan to compare

heres a screenshot of the duratec/eco/disi bell dimensions looking at rear of block. the file is a dxf and it wont let me upload it here. units are in mm and measured from the left most alignment dowel . larger holes are because im using countersunk fasteners there. the others are not threaded...

figured it out. it ended up being a bad circuit relay.

@robander3 did you happen to have any odb2 codes? I think I might be experiencing the same issue. - 9 out of 10 times, My car cranks but doesnt start. - dont hear the fuel pump prime when I turn key to on but i do have power/ground at the 4 pin connectors. was your replacement ecu new or...