Recent content by Reece Andreychek

You guys are the best I will be doing this tomorrow! Grub screw is top tier! I’m so close to starting this pig I did not want to pull the timing cover again lol.

Good evening, has anyone here ever dealt with this? The previous owner or some jackoff who built the motor must have over tightened the bolt, because now it is see-through ‍ and I am leaking fluid through. Any recommendations or tips? Thanks everyone

Doing absolutely awesome man!

Hey everyone, recently I figured out the wiring for my dual aeromotive fuel pumps and I got it to start spitting out some gas. Around 4 gallons came out and I realized that it wasn’t pulling over from the passenger side. I had already verified that the line was on and the clips were on. It did...

Np, will definitely work. If you have any questions I’ll gladly help out

I couldn’t find much info on a coolant hose routing diagram for a speed6. I would really love if it anyone has it. Reason I need it is because the current shell I have came with many missing coolant lines. I am also running a turbo with no coolant lines. Thanks in advance!

Thanks! I’ll do some math lol

Thanks so much for your help. Basically what you are saying is to measure the springs?

Hey all, is anyone able to help me find my wastegate pressure based off of my spring colors? Thanks to anyone in advance!

Erm so me car caught on fire in December. I had them on until then and they felt pretty good to me! Good budget upgrade. Some clowns on FB will try to make fun of you but I thought it felt a lot firmer. Lasted over 3k miles!

Thank you so much bro. So hard to find info!!!

Hey anyone active here that runs a pulsar turbo? I’m at a bit of a loss and can’t find any info online. Have a pulsar 6262e and the oil feed line that everyone says I need to run doesn’t seem to be right. Have a 4AN line to 1/8 NPT. I know the NPT isn’t supposed to go the whole way in, but it’s...

Got some more progress done the past week! I got the engine/trans/t-case/turbo all hooked up Then I was able to plop it back in. And I got my interior 90% of the way done! All I have left to do is deal with some of the f’d wiring under the steering column, and finish up the front end...

I bought them for a mazdaspeed6. You can take yours out and measure them, or look to see if someone else has done it already. Good luck!

Thank you! And …uhhhh….