Recent content by sixth

After i installed engine mounts by damond motorsport and rear differential mounts by corksport, increased vibration loosened car cam sensor connector just a bit to engage CEL. I cleaned the connector from excess debris & sand and reconnected it tightly and didn't get any CEL after 30 miles...

So i got two CELs and these codes appeared P2088 "camshaft position actuator A control circuit low (bank 1)" And also it had CEL P0234 "engine overboost condition" But that code never came back when i reseted the codes. Where to start troubleshooting? I googled a "bit" and found that maybe...