Recent content by Tommy_y0

  1. Tommy_y0

    2001 Audi S4 Avant

    Finished assembling the car about a month and a half ago or so. Been driving it since then, a couple issues but nothing major. Sorry not a huge picture guy I always forget to take them....waiting on a tune for now, just been breaking in the new setup. A little more than 1000 miles on it at this...
  2. Tommy_y0

    2001 Audi S4 Avant

    And where I am at for now. Was going for a polished look on the intake manifold....lost my patience after about 20 hours with the dremel. Will improve later. Timing belt on motor thermostat etc etc and engine covers so on so forth.... Hopefully motor and trans going in this friday ! Sent from...
  3. Tommy_y0

    2001 Audi S4 Avant

    After I swapped the entire suspension setup to make the avant low and the sedan stock again...wheels came on the avant, pretty good looking imo. Bought the ko4s blown so I put some different known good chra's in them and put them back together. Sent from my SM-G950U using Tapatalk
  4. Tommy_y0

    2001 Audi S4 Avant

    Hauling it back to MN from Arkansas....pulling motor shortly after. Found a water leak on car 100 miles after buying it so that's why so soon...this was early September and October last year Sent from my SM-G950U using Tapatalk
  5. Tommy_y0

    2001 Audi S4 Avant

    Hey all kinda long time MSF user, not enough MSO user. Sold my speed a while back and have b5 s4's now. Have a silver sedan, was my 1st one. I got it with a built trans, fx400 clutch and pp, full bolt ons, and tuned on pump gas. Bought a b5 s4 avant that needed a serious amount of work last...
  6. Tommy_y0

    What did you do to your ride today

    Sounds to me like the same issues I had in the rear end trying to install the new coils.... Bolt rusted to the sleeve in the rear passenger control arm. Note: Bolt on the left with the yellow line on it in the attached photo When we tried to bust it loose I snapped the bolt clean off all the...
  7. Tommy_y0

    RaiderFab 1st Gen Mazdaspeed 3 Bumper Fitment Fix

    @Raider, Apologies for first reserving and not responding. I'm not going to be able to swing this for the first batch, so if you haven't sold the bracket set I reserved go ahead. I should be financially tidied up for the second batch though. :)
  8. Tommy_y0

    RaiderFab 1st Gen Mazdaspeed 3 Bumper Fitment Fix

    Did I already miss the payment period for these @Raider?
  9. Tommy_y0

    RaiderFab 1st Gen Mazdaspeed 3 Bumper Fitment Fix

    Add me to the list as well black latches and two MSO decals (preferably white)
  10. Tommy_y0

    What did you do to your ride today

    Finished up lowering the coils yesterday, and finally got the rear's on Wednesday night. New-ish (bought slightly used) suspension is so nice hahaha...
  11. Tommy_y0

    Weird hum/noise under acceleration

    NOTE: I have transferred this thread which was created by me on another forum in hopes of helping someone else! Hello fellow MSO'ers, So I've been having a hard time with this weird hum noise under boosted acceleration on my '07 speed 3. I've got some mods done to it, but I have no idea what...
Back
Top