Search results

Spacers have arrived. Just purchased an angle grinder to cut down the studs.

Spacers have been ordered.

Never thought of that, thanks for the idea.

I thought about that, just dont want to mess them up to where they get cross threaded, lol.

The problem is if the oem studs are too long and i put the spacer on, the wheel might hit the studs before they hit the spacer, there fore its not sitting flush. Not sure if that made sense or not. I guess I should mention that the spacer i would be using has its own studs built in. link below:

That would be better than hammering away until they pop out, lol. The spacers will come with its own lug nuts to secure the spacer and then i have a set up lug nuts that will fit the RPF1's since the ones i use for the evo x wheels wont fit.

I believe the rear either needs a 5mm or 10mm spacer to clear the rear struts. I need to look into that part as well.

Thanks for the info. I plan on getting spacers soon. I just know that the studs were wither going to be to long for the spacer itself to where the wheel would hit the stud before it lays against the spacer or it will be to short and there will not be enough thread to properly secure the spacer.

Question with anyone who might know. I am currently running ISC coilovers with evo x wheels. I have a set of 17x9 RPF1's +45 offset with 255/40/17 Continental DW's that i will be throwing on. I will need a 15 mm spacer in order to clear the struts in the front. I was curious if anyone who is...

Not in my pants!!!

Whalecum to MSO!!!

Congrats guys.

Really hope I can make this one, if we get it done again.

I hope for their sake, nobody.

60K for a FWD Civic, For the same price you can get a used GTR and not have traction issues.

I guess they dont care for pink anymore.

Mainly because i think its a very sexy car that you can buy and mod that wont break the bank. Sure I could have bought a new Evo or STI, but for twice the price and not look as good, it was an easy decision.

With a streetlite and yes i replaced the flywheel bolts.

They wanted to protect their paint job while traveling to Nopi Nationals in Atlanta. A guess going 80+ mph will tear off plastic wrap with painters tap with ease.

I had the fidanza and luk combo and there was a some good chatter. However I upgraded to the ACT 6 puk and flywheel and there is almost no chatter. So the Fidanza and luk and sitting in the garage.