Search results

  1. Nitr0EngiE

    Clutch System Upgrades? MS3 vs MS6

    So some of this is speculation and some of it is based on personal experience as of lately with the car and past reads over the years. Until the other day I assumed there was no upgraded clutch line option for the MS3 and only the MS6 until i was doing my homework on clutches and I am still...
  2. Nitr0EngiE

    clutch goes soft after boost

    So i have been chasing and issue with my clutch. After doing a hit in boost my clutch goes almost to floor and engagement drops really low. (Spec 3+ Sprung Clutch) I already had a revised slave so i replaced master and the same issue was there. Then i put a brand new slave with ate brake fluid...
  3. Nitr0EngiE

    lighted meth tank

    Soi was fixing a meth leak i found in my trunk and i was filling the tank up and i get tired of not being able to see how much meth is in so i don't over fill the tank. I usually try to put a flash light next to the tank but i can't always find one and is not the best solution. So i made a...
  4. Nitr0EngiE

    Stopping Meth Fumes with in cab tank

    So I notice when I fill my tank up in which it does not sit level and there are bumps and such while driving I think a bit of meth gets splashed up through the vent and I normally like the smell of meth, but when you get in your car to goto work it is overwhelming and I don't even want to...
  5. Nitr0EngiE

    How do you remove clutch pedal ?

    So I cam trying to replace my clutch master cylinder and get the clutch pedal out. I have the pedal completely unbolted/unhooked and the clutch master is completely removed from the clutch pedal and for the life of me I cannot get either the pedal or the master out from under the dash .... The...
  6. Nitr0EngiE

    How-To: Fix Accessport and OBD Connection issues (Loose Pins)

    I have forever had issues with my AP saying it cannot connect to the ECU required me to constantly unplug and replug the AP until I could get a connection to flash my map or get a datalog. I heard a long time ago from a guy at Cobb that i would need to get down there and tighten the pins, but...
  7. Nitr0EngiE

    Looking for a Meth gauge solution

    I need a guage with these requirements: 52mm Electric with sensor reads up to 300-350 PSI Sensor is Meth compatible. Discuss options, I do not want a mechanical gauge like you would see on a oxygen tank.
  8. Nitr0EngiE

    Hello

    Hello, I went on to MSF to post some parts for sale and could not help but notice how dead the forum seems so I decided to check and see whats going on. Is the MS platform dying or something? I figure not, then I found this place with most the people from MSF even Raider is here so it seems...
Back
Top