Search results

For the life of me I cannot get my wot box to shoot flames or make gunshots. Iv tried with a dual vta bpv and a full recirculating valve. On my stock motor with a cst5 I could get pops with the 2 step and the occasional flame on ffs with the bpv blocked off. Now that iv got a speed performance...

My speed 6 ecu isn’t sending the ground signal for the coil relay to run the in tank pump. I jumped the 2 big pins and it still keeps the factory functions. With key on engine off it primes for 2 seconds then shuts off. Then when I start cranking it turns on again and runs fine. Why can’t I just...

So Iv got the rear diff out to pull some sheered bolts out of it and while it’s out Iv been reading up on the awd. I don’t know if it’s true but I read that the computer sends a signal to control the amount of power that goes to the rear wheels 0-5.85 volts. 0 being no power and 5.85 being 90%...

So my front rear diff mount bolts sheered off. Ordered upgraded mounts and new bolts but they are 30-60 days away from being shipped. I need my car as a daily, my actual daily blew the head gasket. Was just wondering if anyone knows if I can remove the rear diff and axles along with the...

Having a weird vacuum leak with a jdm engine I swapped into my speed. I pressure tested the intake and there are no leaks. I have always ran the valve cover vent disconnected and the intake port plugged. I ended up putting my finger on the valve cover breather and could feel vacuum. I could also...

Iv got a really weird issue on my speed6. Brand new speed performance motor primed and ready to start but cranks and doesn’t start. Hpfp actual pressure won’t go over 80 even while cranking. Popped the # 1 plug out and it has gas in the cylinder. While the plug was out. I decided to check for...

Got my built motor put in and the car won’t start. Had it towed to the dealer and they are telling me the fuse box in the engine bay is bad and needs replaced. They told me 20 hours of labor because they have to pull the dash and all the wiring harnesses. This cannot be right just to replace a...

Iv been battling this weird issue where afr ramps up to mid to high 12s during wot then back down. I also have the infamous hesitation/backfire after shifting form 2nd to 3rd while at wot. When this occurs afrs ramp up to the 13s right after the hesitation. I’m on e25 and fully tuned my tuner...

I just installed the white line sway bar on the stiffest setting. Are there any options for front sway bars? Obviously softer than the rear but stiffer than stock?

Remanufactured motor with 2k miles on it. Just started noticing this weird issue where it’s really jerky trying to take off and while cruising. my afrs are oscillating while this is happening. Any idea what this could be? car pulls hard and idles good just when I take off and cruise.

I have a speed6 with a remanufactured atk motor. Ever since I started breaking in the motor it has had crazy high kr at part throttle and won’t stop until I let off and 5.95 at wot consistently. Had the engine taken apart and checked and it is solid nothing is wrong. Knock sensor replaced and...

2006 ms6 always had a slight vibration on accel in 1-3 kinda like really bad rotors but when I’m accelerating not braking. The real issue is when I launch the car I get an awful clunking noise. Any ideas? Sounds like it’s coming from the passenger side or slightly to the left of the shifter.

2006 mazdaspeed 6 121,000 miles fully bolted minus turbo. I noticed I’m losing about a quart of oil every 1,000 miles or so. Compression is 180 165 155 170. I haven’t for sure figured the oil loss and compression is related I do have a few leaks and no catch can and never replaced the pcv. My...

So this is gonna be hard to explain but I’ll give it a shot. I have a 2006 mazdaspeed 6 with 120,000 miles. Mods are cs sri, injector seals, tr8 tread stone fmic, downpipe, hpfp, ap in the process of protune, one gallon of e85 15 gallons 91. The problem I’m having is when I go wot after I shift...

Just got my speed where I want it and I was driving it going about 30 started to roll into a pull and then my engine just shut off like a blown fuse. Lights stayed on when I try to start it I get a single click from the fuse box but nothing else no crank nothing. All fuses are good battery is...

I have a 2006 MAZDASPEED6. It has 120,000 miles on it. It is completely stock minus a bov. Cs injector seals, and an ap with a stage 1 Cobb ots map. I have hpfp internals, dp, and a tune on the way. I get wot kr builds slowly up to around 3-5 depending on bats. Can’t seam to figure out what’s...