Search results

Within the last 2-3 months I have noticed an intermittent stumble while driving that seems to be getting worse, and I think accompanied by a sulfury smell from my exhaust.... Check out the logs I've posted, I think my AFR is f**ked and that is throwing everything else out of whack because I...

Year/Make/Model: 2009 Mazda Mazdaspeed 3 Mileage: 196582 Location: Tucson, AZ DTC's: P2188 and P0302 Modifications: Cobb intake, EGR delete, balance shaft delete. rebuilt engine myself, now has about 10k miles on it. all machine work was NOT done by me. bored out .5mm over, same internals except...

Does anyone have a diagram for the bolts how the tranny bolts up to the block? I am going to be doing a rear main in the next couple days and I want to make sure I buy a new set of these bolts because when I did it last time I kinda just put stuff where it fit, but I would like all of the...

Hearing this...grinding noise? Weird kinda rumbly/shaky noise when the engine is under load. Can be from start, or even at 40mph in 4th or 5th gear. Does anyone recognize this sound before I start pulling shit apart or assuming the worst? Ignore the shaky sunglasses in the beginning, you'll...

Wondering if you guys have any thoughts about this situation. Log is attached. Recently installed a Damond PCV plate, new PCV, stage one catch can, and oil fill breather cap. Other mods are minimal, Cobb intake, balance shaft delete, mild tune from versatune, stock K04, larger turbo inlet, EGR...

So today I was installing a new amp for my door speakers. During which, I noticed an enormous bundle of wires hacked into the passenger footwell wiring harness with these t-junction things...I noticed that the other side of this rats nest wasn't connected to anything, it was just tucked up away...

Yo! Just about to do my first oil change post engine break in after a rebuild and I had a question about oil capacity because I am finding some conflicting information online. Balance shaft delete. Spin on oil filter conversion. So WHAT is the oil capacity on this car with those two mods? Or...

Recently finished a rebuild and now I am trying to hunt down a raw fuel smell when I am accelerating. I had a friend sit in the car and rev the engine for a few minutes while we were at my house and couldn't see any leaks under the hood, nor could I smell any fuel whatsoever. Then we took it...

This is a link to my car running. Recently did a full rebuild, and the only real addon performance stuff I did was a new turbo inlet pipe. It has a full Cobb intake, no tune w stock ECM. Did a balance shaft delete and a new rear motor mount and holy god this idles like an actual race car...

I've been struggling after a full engine rebuild lately, so anyone's input would be appreciated! Got everything back together, started the car up and it is running kind of weird. No real mods besides a few bolt ons. New turbo inlet pipe, cobb intake, rebuilt stock K04 turbo, balance shaft...

So fucking frustrated and over it right now. I went to bolt my exhaust back up and I could not figure out the bolt/spring combo for the life of me. If anyone knows the correct orientation of the bolts/springs to bolt the stock downpipe to the mid-pipe, I would be eternally grateful because it...

Just as the title says, finishing up a full rebuild and I can't find this slave cylinder hydraulic line retaining clip for the life of me. I would much rather find this little inexpensive clip, than spend 140 bucks from Edge replacing the entire slave cylinder. Does anyone know where I can...

I tore apart my engine in July, and finally got around to getting everything back together this week IE block, head, and getting all the parts I need. I thought I did a good enough job labeling things but apparently I did not, and now I am at a loss for what part this is! Can anyone help me...