Search results

Rgurleyjr what was the cause of your issue.I have the same problem!!!!!!!!

No yet, that is my plan for tomorrow, i hope that is the case because i looked on the workshop manual and the symptoms that i have are not even there.

if i do that window doesn't do any further, up or down.

So, I have a 2006 Mazdaspeed 6 and some reason I cannot roll down the rear driver window all way down or up. No matter witch control I used The window just move about 6 inches in either direction and stop.I already disconnected the battery with no luck, Does anyone one has a idea of what may be...

OP what was the final outcome on your issue???????????

I will try that thanks for the help!!

Thx for reply noob question, how do you power bleed the master cylinder? never done it.

I just did a motor swap on my speed6 and y replace clutch with a LUK clutch set, & Slave cylinder. My problem is that when I initially bleed the system, slave clutch was engaging now two days later it stops engaging. Pedal feel the same as before but when the engine is running I cant find 1,3...

Oh ok I got you.I see the waste gate duty cycle going over 50%+ in a few cells right before the spike. The problem is that old maps that were working normal (not spike)now have boostpike 23 psi.What would be the explanation for that?

Is not he tune because I switched(3) maps same outcome, and I run that map that you see the log a spring pressure no spike 12.5 psi so is not the map.I aleady change al my EBC lines, switched map to a map that was spot on 3 weeks ago, check waste gate flapper (tested with air compressor) double...

The boost target is 20psi and I am overboosting to 24psi and it just started a week ago, I switched to a old map that I know as running good 3 weeks ago and same outcome. I am currently running spring pressure an I see 12.4-13.00 psi WOT. Here is one log.

Revviving a old thread!!! I am having a over boost situation during the initial spool. The map commands 20 psi and I am hitting 25+ for a few frames(5) on the datalog. My tuner told me to check the ebc lines and the connectors (cap)on the waste gate actuator .I am currently checking the actuator...