Hi I recently swapped out my gen1 engine and put gen2 1 n my Ms6 I used everything from my gen1 basically a bare gen2 engine went in it starts I got no codes but something isn't right if any one has done this and knows why I'm having trouble pleas any help at this point would be much appreciated
Ms6 gen2 engine swap
- Thread starter Jerms83
- Start date
if you used all of the MS6 accessories then there is no issue with using the MS3 gen 2 motor.
if it starts and has no codes what exactly is the problem?
if it starts and has no codes what exactly is the problem?
My MS6 motor is a Gen2. I saw in the shout-box you had mentioned the knock sensor. Just as Afwican had asked, did you torque it properly?(hand tools/torque wrench). WSM states NO IMPACT TOOLS. also, im not sure if it'll affect it but maybe the orientation can affect it. 