Just had a downpipe and dumptube fabricated for my '09 speed3, as I went full vband turbo setup, pte5558. Along with the graveyard performance tubular exhaust manifold, under-mount. I am running in to an issue where my O2 sensor cables are way too close to hot pipes. I have tried looking through the forums for suggestions on extension harnesses, but have had no luck. Any guidance is appreciated.
O2 Sensor Extenstion Harness
- Thread starter zindree
- Start date
It's not that many wires to just cut and slice to make it longer
If you don't want to cut it up you might be able to make your own extension.
https://www.bmotorsports.com/shop/index.php/cPath/103_108?osCsid=bibg5aosenv88c1m5nhlmfuoc1
https://www.bmotorsports.com/shop/index.php/cPath/103_108?osCsid=bibg5aosenv88c1m5nhlmfuoc1
That's a fair point. Current o2 sensor seems to not be working, so may as well use the wires from it on the new one, huh?
Appreciate y'alls suggestion, and link to parts.
Last edited by a moderator:
Just a followup, for anyone wanting to get a harness made, bmotorsports.com has these available:
https://www.bmotorsports.com/shop/product_info.php/products_id/5353
https://www.bmotorsports.com/shop/product_info.php/products_id/3401
The individual parts are also listed, if you want to make them yourselves.
https://www.bmotorsports.com/shop/product_info.php/products_id/5353
https://www.bmotorsports.com/shop/product_info.php/products_id/3401
The individual parts are also listed, if you want to make them yourselves.