Latest activity
-
StreetSpeed6 replied to the thread Faulty Fuel Pressure Sensor.Yes they were and I done a boost leak test before all this and did find a couple small leaks that I fixed. It is possible I had those... -
Already relayed that test to him. Need to compare old vs new logs, pref both KOEO and hot idle.
-
The LTFT where ~20ish on your previous log. Did you check the sensor voltage on key on engine off? What was the pressure at idle?
-
Already relayed that test to him. Need to compare old vs new logs, pref both KOEO and hot idle. -
Enki replied to the thread Faulty Fuel Pressure Sensor.Already relayed that test to him. Need to compare old vs new logs, pref both KOEO and hot idle. -
OMISPEED3 replied to the thread Faulty Fuel Pressure Sensor.The LTFT where ~20ish on your previous log. Did you check the sensor voltage on key on engine off? What was the pressure at idle?
-
StreetSpeed6 replied to the thread Faulty Fuel Pressure Sensor.Ok so sensor # 0261545074 did allow my car to run but my Short Term Fuel Trims were -25 and my AFR at a partly warmed up idle was...
-
-
Easter Bunny replied to the thread Mazdaspeed engine build.Donate -
Raider replied to the thread Maxpeedingrods Turbos.S1 is stock. S2 is heh. Go for a CorkSport CST4 or 5 depending on goals. I have one of the first CST4s, like 3rd one for production, and... -
Aurquilla96 replied to the thread Mazdaspeed engine build.Thank you! and I hate to sound dumb, but I am new here... Where do I find the metal member section?
-
Aurquilla96 replied to the thread Maxpeedingrods Turbos.Ive thought about upgrading my turbo when I replace my motor. Would a BNR S1 or S2 be fine? Im not looking for crazy power but I do want...
-
Aurquilla96 replied to the thread Clutch bleed help.I have found if youre able to put pressure in the master cylinder almost like a brake flush. You can unbolt the slave and tilt it up to...
-
I'll do my best and it will be as OEM, trust the skill The OEM bumper won't be needed strictly anymore but why I'll announce here...
-
It depends on the actuator, but you generally don't want the membrane to touch/rub or it will puncture and then you have zero control on...
-
Enki replied to the thread Low Boost MS6.It depends on the actuator, but you generally don't want the membrane to touch/rub or it will puncture and then you have zero control on...
