I'll try to make it as short and detailed as possible. Got a 2010 ms3. Been doing basic maintenance on my speed the past year. After 15 short...
My genpu has a rough idle where it makes a small sputter every few seconds, I also get a p0300 random misfire code that comes on every few cold...
I'm part way through replacing my timing chain and vvt, I just torqued the cams and afterwards was able to fit the locking plate back in with some...
Timing Cover Install and Timing Pulley NOTE: The Timing Wheel is pressed onto the crank pulley. If you plan to make some decent power and bounce...
Installing Timing Components Pro Tips Pretty much every bolt tq sequence is a criss cross or start in the middle and circle out. When in doubt...
Timing the Motor - it's not that bad Here is the quick and dirty of timing this motor. Take Cams Out Set Cyl 1 to TDC and use TDC Pin "double...
Please be patient, I am going to start creating a guide for tuning on pump gas. I am not an expert but have been successful on my own car. If you...
Separate names with a comma.