Recent content by Adapted_Performance

Looking good!!! You should still be able to tighten the set screws without removing the oem cap using the supplied hex key (short side). install.webp

I really appreciate the review. I developed these in response to those crappy SSP's that are on the market. This whole assembly is not much lighter than the factory weight but the way I have the weight distributed and offset makes a difference. Also for the shift length, we go as short of a...

Looks like you are running a custom made phenolic spacer? If so, that by itself will not seal, you need to run a gasket between the spacer and the head and the spacer and the manifold. But, I have single runner .093 thick tig / gaskets being cut now. Hope to have those back next week...