Recent content by Erebus

Thanks, i wound up replacing the whole hpfp housing and spill valve with a used one and swapped my autotech internals over. Solved my problem.

Fair enough, didn't think about that as we don't do OBD2 emissions checks here. Our ECU uses the MAP sensor to detect EGR flow, basically opens the EGR under high vacuum and checks to see if vacuum increases, if flow is not detected after a few cycles it throws a CEL. Will Dawson and a few...

Funnily enough mine came with my corksport exhaust. Yip that is the type used though i don't recall the exact dimensions, the thread is a m18 x 1.5. All this BS about avoiding CEL and such is why i ditched cobb and went Versatune. Worth thinking about IMO if you are thinking about an...

This is anecdotal, but I've run a catless exhaust in my ms6 for nearly 2 years with no CEL. Used a simple o2 sensor spacer.

I'd say that the custom piping setup you currently have is built around that blow through and getting a long straight run for it, I don't think there will be much in the way of off the shelf piping kits that don't have a bend in up from the bottom to the TB. Putting it above the CS FMIC might...

Nope it's VTA, the thin line going to the intake manifold is the vacuum source to let your BOV know when to open. If it was recirc, there would be a much larger line running from the BOV to the intake. The blow through MAF setup is interesting, not super common on this platform.

Awesome work dude, keep it up! For intercooler piping routing with the FoST mani, check out Mastermind's build thread, his is Genpu but he has the same thing with the long straight section on the cold side, might give you some ideas...

Yup, they are the Yazaki 1.5 System Sealed Socket Contact.

It's a M10x1.25, 25mm thread length.

Speed Solutions makes a cold pipe that is a decent off the shelf option. Other guys have made their own from parts or by modifying their existing piping: https://mazdaspeeds.org/index.php?threads/focus-st-mani-install-and-how-to-keep-your-existing-piping.6195/...

Is that all? Nah, just send it :p

I have the Sure mounts and replaced mine about 2 months ago (yes, Sure sucks, I bought mine from a local who had them but never installed them). I did front and rear without dropping the subframe with the diff resting on a floor jack. For the front mount my bushings were pretty tired so if...

Hi all, I have a 06 Speed 6. Looking to add bolt on mods so first step is the HPFP. Couple of weeks ago I added some autotech internals and rebuilt the HPFP with the corksport rebuild kit. The results of this have been underwhelming to say the least, fuel pressure readings seem to be lower at...