Recent content by Skunky82

Anyone have the length, thread pitch, and size of the inner camber arm bolt handy? Rounded the passenger side bolt and still working on getting it out. Figured I'd pick up a replacement while I'm out getting an extractor set.

Can do

Have put about 25 miles on them, was expecting a bit rougher than stock but the ride quality is equal with oem. Haven't adjusted the dampeners yet, waiting for everything to fully settle then get an alignment. So far, I'm happy with the purchase.

Yeah, a 2x4 and a 3lb dead blow hammer were used. First time doing a suspension upgrade and going at it solo just made for a long day.

This weekend I fought with, wrestled, spit at, and cursed the OEM suspension while installing Corksport shock/strut and spring package. Finally got it installed, getting those front knuckles off the OEM shock was painful. Rear install was a piece of cake.

Finally installed the 80duro PMM from JBR. Vibe and noise increase but engine is much more solid feeling. ************** After driving around some yesterday evening and this morning I went ahead and put the TMM in as well. Was worried the vibes and noise would increase significantly, but they...

Monies sent for 2 XL Tshirts

Member of the previous forum from a few years ago. Had just started to get into modding my genpu when life got in the way. Getting divorced, suddenly becoming a single dad of three, and working through that and other drama brought a screeching halt to the mods and I had to step away to get...