Search results

do you have an Idea of what is the problem? have you done something or change something juste before having the problem? m'y car only start if i unplug the maf sensor, it run Bad until 3000rpm but higher, it's fine..

hi, i opened my bov, nothing damaged, the seals are good, the piston moves freely, the spring is good ..nothing strange here...

you mean the blow off valve, can fail and suck air into the intake ? that's a 2 way one, a Big part goes recycle and a few air goes out.. the spring for thé free to air ouput is a hard one, i mean, it make noise only if i lift gas when boost is over 1 bar... (14psi) it was working good before...

hère is the picture.. there is epoxy on the hpfp plastic part on top, as the top of the plastic part seized a little when unpluging it,, so i put epoxy on it before it breaks completely.. the problem isn't there, as it was not broken until now... lol

hi, i've removed everything, i put corksport injector seals ( the Cooper ones ) i test all 4 injector with multimètre, 1.3 ohm each.. i have removed egr pipe and blanked egr ports ( screw on the manifold and plate on the egr pipe output ) egr is still plugged. i put the rail, manifold, and...

initiale, the car was fine, but i had huge fuel leak betwin injector and fuel rail, when i removed the rail, i have seen it was dead, there were holes in the rail where O-Ring are.. (sorry for m'y english) so i replace everything... since the car stall...

hi, i have replaced injector seals, just to be sure that air was not entering here, i put some corksport Cooper seals, and i'm still having the same issue.. afr 22, stft +25, and car dont start... it cranks... it run 1 second, then rpm goes nearly 0, then it revs to 1500 RPM half a second then...

hi , everybody.. :-) so i have checked fuel values: ican't start the car with maf sensor plugged.. * engine off: 40 psi (non crank for 2 days) * idle warmup: 1400-1600 psi ( with maf unplugged ) vacuum -0.4bars - afr 22 * idle motor hot: ( motor shaking, nearly stalling ) 1000psi - vacuum...

thank you, i will look tomorrow, but if i remember.. i have near 25 psi when off, 480 at idle (without maf sensor .. ) 1400-1500 a 3000 RPM stable, and 1900 when wot ( in neutral Gear... ) i have autotech hpfp internats, when it was normal, it can go to 2100.. the ground near hpfp was...

hi, thank you, i will try to make a log, i have no DTC or light on dashboard.. non stored code, only maf when i start thé car without. the only Bad things are vacuum pressure that goes too high and that make engine stall, and stft at +25 when the car wants to start with maf plugged. when maf...

Hi, i have a problem with my cx-7 it don't start at all, it cranks normal, start for 1 or 2 seconds, then stall... if i unplug maf sensor, it is starting but idle raise UP and down, and afr is 20-22... :-( stft AT 0 if i turn it off, plug black the maf, and restart, sometimes, it runs, but...