clutch

Hi, im new here. not finding much help on the internet, its like 100 degrees out, which means i havent crawled under it yet.... so i figured it was time to sign up. I have a 2007 mazdaspeed3. 110k miles. Anyway, i was driving earlier, in town, casual. light turns green, i push the clutch, it...

7 months ago I had a very trusted and reputable performance shop install a clutch on my speed3, I went with the classic Luk+Fidenza combo, well one day last week doing pulls it slipped badly, and still does only in full WOT tho, normal driving is perfectly fine still, I need help on what could...

Hey guys, First off I'd like to apologize if this forums is in the wrong thread. My 08 speed lost clutch pressure one day as I was driving. so I took it home and started to go to work So far I have replaced the master and the slave cylinder hoping that would solve my problem but sadly no. When...

I’m looking for some advice… I’ve got a 2008 MS3 with relatively low mileage for its age (86,000). I’m the original owner, I’ve taken good care of it, but it’s reaching that age when things start to go wrong. Given the current state of the US auto market, I would rather not replace it right...

Hey all, I'm creating this thread to share the symptoms, diagnoses and solutions I found when my clutch pedal feel and clutch biting point started to change this winter for my 2010 Mazdaspeed3 with 140,000kms. The Original Symptoms: After some regular highway driving, I started to notice the...

Hi guys this is my first post, I just bought a msp6 a few months ago and it had a stage 3 ACT clutch and flywheel on it along with a new motor with 88k miles and other mods such as upgraded CS4 turbo, V3 accessport CS injector seals, CS HPFP internals, Raceland coilovers, CS cams, intake...

New member, just picked up a 2012 Speed 3 a few months ago. Just a bit of background- I learned stick maybe 10 years ago but this is my first manual that I have owned, so while I can certainly get around, I am still a noob. The problem I am having is 2nd gear grinds with the clutch all the way...

So I’ve ran into a problem. I was bleeding slave cylinder and not my clutch pedal bracket broke up from the the clutch pedal. Is there anyways I can get just the bracket that’s holding into the firewall that holds the pedal? Or I have to get the whole assembly? Thank you.

UPDATE: 4/2020 After using this for a while it appears that the speed 6 bore is not going to work with the speed 3 master cylinder. It creates too much pressure for the master and screws it up. You can use this guide to make your own 3an line setup but for now this is not a solution. UPDATE 2...

I recently went built motor and installed an ACT 6 puck "zx5-hdg6 kit". The first 1500 miles or so the clutch engagement was about 3/4 up the pedal. This seemed about right and took a little while to get used to as the pedal is heavier and grabbier then stock but after no time I had it figured...

Hey folks, I have a 2012 Speed3 that I picked up as a CPO. Bought at 33k, now at 52k. Recently the clutch has been grabbing all the way at the end of the pedal, and I recently had it bled, and that didn't do anything. I'm guessing the clutch is starting to go, if that is the case. I have no...