2011 MS3 throwing two codes and traction control light stays on

M

Mysicksi

Greenie N00B Member
Hey all. I recently drove my 2011 MS3 for about 30 minutes with no issues. After I parked it and came back to turn it on, I started to throw two codes, along with the traction control light staying on. The codes are P0098 and P0108.

Here are the steps I have taken so far
-Replaced both the IAT and the MAP sensor
-Reset the ECU by disconnecting the negative battery terminal and pumping the brakes 5 times
-I tried to clear the codes multiple times with my access port

Nothing has worked so far. Does anyone have any ideas on what the next steps would be? Thank you.
 
Three unrelated issues at once, with two being circuit high codes.
I would start by looking for damage/corrosion around the pcm connectors.
 
was this issue ever successfully diagnosed? Im having the same problem and cant figure it out, I have already inspected the pcm connectors yet I dont see anything out of the ordinary.
 
You must log in or register to reply here.
Back
Top