Boostedhappiness
Greenie N00B Member





It weighs 84 grams. Once completely dry I will sand the edge smooth/straight.
Im going to make some Covers for the PS and Coolant jugs next using the same method.
if anyone is wondering how much it cost, I bought 3 rolls of carbon (200mmx1000mm each for $60 CAD (cheap) and I went to micheals craft store and got thier clear epoxy casting resin using the %40 coupon it was under $20.
I only used a half a roll of the carbon and half the resin.. (I bought a small pack of epoxy resin to experiment, I will go back tomorrow with the same Coupon and get the bigger jug haha)
I didn’t use any mold release, I put the bin in the freezer and that sucker popped right out of there. I can reuse the container to try again if I want.
and on a side note : don’t use that gold foil near your exhaust, I bought the car with a gold foil heat shield behind the turbocharger, well last night it caught on fire, luckily I was only 5 or 6 blocks from home. I was able to drive the car home and extinguish the fire with the garden hose. I can say I have never been more afraid of loosing my car, there was thick smoke billowing out my windshield wipers and coming into the cabin. I had someone jaw dropped staring as I drove by.
replaced with metal!!! Hopefully nobody else has this stuff on thier firewall because that’s what it turned into… a wall on fire!