Im back baby!!

harambespeed

harambespeed

Greenie N00B Member
After a 4 year hiatus of car building I finally have the time and place to continue building my 07 speed 3. I bought the car about 7 years ago and had a few nice upgrades such as turbo and other bolt ons. Ended up blowing the motor and had the entire long block rebuilt and ready for 850+ whp. I had Vincent back a few years ago completely blueprint and build my motor from Corksport. Ended up being one of the first and few staged builds done by them. Here is a complete list of parts I've invested over the years. hoping to have this bad boy roaring by the end of the year

Engine Mods

Engine Mods
Manley Platinum series pistons
Manely H-Plus 625 Rods
Sp63 H11/625 Head Studs
Arp main studs
Corksport Injector seals
BSD
New Oil Pump
New VVT
All new bearings/washers
Garrettt GT3071R
COBB AP V3
Large FMIC
CS Cams
CS 3.5" Power Series Intake System
CS Rear, Trans. & Driver Race Motor Mounts
CS Dual VTA Bypass Valve
CS 3.5 Bar MAP Sensor
CS Aluminum Pulley Set
CS Silicone Bypass Valve Hose
CS Max Flow Fuel Pump Internals
CS Injector Seals
CS Oil Catch Can
CS Short Shift Plate and Shifter Bushings
CS Boost Controller
CS HP Fuel Line
CS Adj. SS assembly
CS Oil, Boost, Oil Temp Gauges
CS OTP Gauge Adapter Plate
CS EGR block off
CS Intake Manifold
CS Throttle body
CS Vacuum/Boost Distribution Block

PICTURE OF ENGINE BAY WHEN I GOT IT


EXTERIOR AFTER A CLEAN
 
You must log in or register to reply here.
Back
Top