Infp won’t prime

rmettler001

rmettler001

Greenie N00B Member
I swapped my infp and now it won’t prime but when I hook it to the battery it primes I’m confuse and getting frustrated someone please help


Sent from my iPhone using Tapatalk
 
Why did you swap the ITFP? Have you checked the pump resistor thing in the engine bay on the drivers side near the transmission/headlamp?
 
L337TurboZ said:
Why did you swap the ITFP? Have you checked the pump resistor thing in the engine bay on the drivers side near the transmission/headlamp?
Click to expand...

Had to get a e-85 pump but I have not Is that the little thing that says caution hot?


Sent from my iPhone using Tapatalk
 
should be. youre applying power at the top of the fuel pump assembly right and its kicking on?
 
If your security light is flashing it will disable the fuel pump. Try disconnecting the battery for a few minutes then reconnect. Sounds like it lost its key programming somehow
 
L337TurboZ said:
If your security light is flashing it will disable the fuel pump. Try disconnecting the battery for a few minutes then reconnect. Sounds like it lost its key programming somehow
Click to expand...

I don’t have the original key that’s the problem I’ve tried that Mazda isn’t any help shits stupid
7028a486c43fdf9ef245faf5bc9cc50b.jpg



Sent from my iPhone using Tapatalk
 
Is the key you're trying to use one that has started the car before? If it isnt programmed it wont start the car, you'll have to call a locksmith or take it to the dealer for them to program it
 
L337TurboZ said:
Is the key you're trying to use one that has started the car before? If it isnt programmed it wont start the car, you'll have to call a locksmith or take it to the dealer for them to program it
Click to expand...

This key worked for the past 6 months


Sent from my iPhone using Tapatalk
 
Ok just try disconnecting the battery for 5-10 minutes, then reconnect it and try again. You drove the car before doing the pump correct? Had it been sitting for a while?
 
L337TurboZ said:
Ok just try disconnecting the battery for 5-10 minutes, then reconnect it and try again. You drove the car before doing the pump correct? Had it been sitting for a while?
Click to expand...

Yes drove the car then blew vvt so replace a ton of parts and it primed prior to the replacement then it wouldn’t prime so I replaced the pump now the security light is on and and no prime


Sent from my iPhone using Tapatalk
 
You must log in or register to reply here.
Back
Top