magikflight
Greenie Member
I have a motor that was missing on cylinder 4, same code you have. Burnt exhaust valve was the culprit.
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
Misfiring cyl 4
- Thread starter Bronson9856
- Start date
- Watchers 9
Bronson9856
Greenie Member
how bad was that to get fixed? What did you have to pay for that?
magikflight
Greenie Member
Tbh I’m not sure. I bought the car like this. I am replacing the whole motor. Compression was shit on the other cylinders. Gunna put a built motor in it. Car hasn’t been on the road in close to 3 years.
Sent from my iPhone using Tapatalk
Cx 7 motor is lower compression. It will work but performance will suffer
Ssinstaller
Greenie Member
IIRC the CR was 9.5 just like the ms6/ms3, only the turbo was slightly smaller.
They run regular fuel though.
Bronson9856
Greenie Member
Just to give an update, my mechanic is swamped at the moment. He says he has started it up a couple of times and he said that it seems like a blown head gasket. He is going to get to it in the next week or two. I fortunately have another vehicle to drive, so it hasnt been a hurry. I will keep the updates coming.
Bronson9856
Greenie Member
Well, finally got an update. . My mechanic that was going to work on this got swamped and didn't want to take it on, just because he has other minor stuff that he can do and make more money. So it sat for about a year, since I have another vehicle to drive. So I took it to another shop that was recommended. They found the issue in the head, A BURNT VALVE! The head was taken off and reworked with 2 new valves, valves seals, etc. The Head put back on and the car runs like a champ! It cost about $2200, but at least I have a running vehicle. . and BTW, this completely solved my issue with it burning oil too. It was burning probably about a quart a week. Now, doesn't burn a drop! So everything is good on the homefront. . for now.
Doesn't seem to expensive for the amount of work either
jsilva
Greenie Member
Although not directly thread related, I’m curious about this. What would be different that would cause lower compression? Couldn’t the fuel requirement be simply a tuning issue? (I’m genuinely asking, I have no actual opinion since I know nothing.)
I always thought the motors had lower compression and a smaller turbo
jsilva
Greenie Member
I have no reason to think you’re anything but correct. I’m just asking what about the essentially same engine would make it have lower compression?
I meant static compression as in compression ratio
Shorter pistons or rods
Shorter pistons or rods
