hollar1211
Greenie N00B Member
finally changed out my worn, front sway bar bushings. the knocking and rattle has been driving me crazy for a while now.
What did you do to your ride today
- Thread starter CmdrShepard
- Start date
- Watchers 119
Compression test Sunday all good 165 psi all cylinders
Also rolled over 70 thou km on my 13
Such a good feeling when you know your rods are all straight and your rings are all consistent. Convert KM to Miles so your mileage goes down.
Sent from my iPhone using Tapatalk Pro
Awafrican
Moderator
Definitely a nice feelingSuch a good feeling when you know your rods are all straight and your rings are all consistent. Convert KM to Miles so your mileage goes down.
Sent from my iPhone using Tapatalk Pro
Finch204
Greenie N00B Member
Got in the car, drove off the driveway and a couple of seconds after I got the tire pressure warning light. Drove the car back and got the keys to the wife's CX-5 and drove that to work instead. Looked like the left rear tire was flat, but didn't have time to check as I was already late for work.
Ordered touch-up tune from Freek so I can install Code Monkey's 3" JBR whale peen when it arrives, along with a Bosch 3bar MAP. Waiting on CS RSB to make it through the Midwest winter storms so I can put that and new Moog end links on. Also just grabbed mas Rotella and a new filter to do an oil change this weekend.
We had a quick uptick in temps to about 40* last week, and now my body says TIME FOR SPRING, LET'S GO WORK ON THE CAR.
We had a quick uptick in temps to about 40* last week, and now my body says TIME FOR SPRING, LET'S GO WORK ON THE CAR.
Corksport RSB and Moog rear endlinks are installed! Doing the oil change tomorrow. Intake install comes as soon as my touch-up map is received from Le Freek.
Sha-BAM! 3" intake and Bosch 3bar MAP installed. Also finally threw in my DM EGR delete while all the requisite pieces were out of the way. Just gotta dial in this touch-up with Justin!
Finch204
Greenie N00B Member
Had to get a tire replaced because the screw that punctured the tire, was really close to the inside edge. That sucks.
However the good news is that I am on the 4th map from @Jason@DizzyTuning and the car feels really strong on the highway. Will hopefully be able to get some datalogs soon now that I no longer drive on a donut.
However the good news is that I am on the 4th map from @Jason@DizzyTuning and the car feels really strong on the highway. Will hopefully be able to get some datalogs soon now that I no longer drive on a donut.
Maisonvi
Grass-Roots Vendor
Wow I actually really like those. Do you have to drill holes to install them?
du_juan
Greenie N00B Member
No, no drilling at all. It comes with all the hardware you need. It takes no more then 10 minutes to install.
[doublepost=1486142904][/doublepost]Got around this morning to install my two Sa-10's and amp. It slaps
Attachments
hollar1211
Greenie N00B Member
Sweet. Do you have the stock Bose system? I've been planning on doing this with my gen 1. So far I've run the power cable. I'm a bit nervous about tapping into the pre-amp wires to run the aftermarket amp. Is that what you did, or did you go the Pac-oem-maz thing route?No, no drilling at all. It comes with all the hardware you need. It takes no more then 10 minutes to install.
[doublepost=1486142904][/doublepost]Got around this morning to install my two Sa-10's and amp. It slaps
du_juan
Greenie N00B Member
@hollar1211 I do not have the Bose. So I can't help you there my friend. But, I did install aftermarket speakers and the amp under my driver seat.
This morning I sent my first logs into Rob over at Hypnotic to get a base map and then start on custom tuning!
