Latest activity
-
ClintH replied to the thread Contrive AWD MS3 Build.That about catches things up for now. I'll update as the real work on the AWD parts of the build start. The biggest hurdle I see at... -
ClintH replied to the thread Contrive AWD MS3 Build.Alright, on to the work... Engine and transmission came out of the car back around the beginning of Aug. The engine has been getting...
-
-
ClintH replied to the thread Contrive AWD MS3 Build.Next, rear diff: You have a couple options. You can either use a straight CX-7 rear diff, or you can combine a MS6 rear diff housing...
-
-
Hi Guys, I've been posting a few updates on FB, but figured I'd start a thread here to document the build process for anyone who might... -
Alright, all that out of the way, here's some catch-up from the last year or so: First was sourcing a CX-7 rear subframe from an AWD...
-
ClintH replied to the thread Contrive AWD MS3 Build.Alright, all that out of the way, here's some catch-up from the last year or so: First was sourcing a CX-7 rear subframe from an AWD...
-
-
Hi Guys, I've been posting a few updates on FB, but figured I'd start a thread here to document the build process for anyone who might...
-
-
Enki replied to the thread Blown Head gasket? Very sad event...You'll have to take the intake out to see anything most likely. Just use a flashlight and look for shiny if you're sure everything will... -
SyntheticAtmosphere replied to the thread Are you sitting comfortably? build.I believe the gauge is looking for a signal from a Hall effect or magnetic sensor in the form of a square tooth signal or oscillation... -
SyntheticAtmosphere replied to the thread Are you sitting comfortably? build.Sloww pretty much covered it, you can have pressure and low flow. Pressure requirements also change with boost levels in the intake...
-
automaticonlyspeed3 replied to the thread Blown Head gasket? Very sad event...thanks for he responses.. I need to check out the metal pipe, see if it’s rotted I took off the intake and battery box and hooked up... -
-
Easter Bunny replied to the thread 2012 MS3 Stuttering Under Load (Logs).Could be the wiring harness. @Awafrican had a lin get bent and not insert all the way that gave him hell for a while so look at the... -
cbrandxn replied to the thread 2012 MS3 Stuttering Under Load (Logs).Ok, sounds good. I’ll swap them tonight and see what happens from there. Honestly never thought that OEM coils from the dealer would die... -
This is why you run mostly water (30% meth or lower) and don't tune for it. As for clogs, etc, fair enough. If you're running pre-TB... -
Enki replied to the thread Are you sitting comfortably? build.This is why you run mostly water (30% meth or lower) and don't tune for it. As for clogs, etc, fair enough. If you're running pre-TB...
