Latest activity
-
_UsUrPeR_ replied to the thread 2006 Mazdaspeed 6 bogging at boost.D'oh. Check the photo again. I attached after posting. I did a full disassembly and cleaned everything less than 100 miles ago on the... -
Raider replied to the thread Raider got so Buzzed.Yeah wasn't a big deal when I had mine. Hose clamps were nice. Now there are better setups for filtration and fueling. Plus Blazecut... -
Enki replied to the thread Raider got so Buzzed.I was actually referring to air cooled engines. From the factory, they all came with push on hoses for fueling that would degrade over... -
Raider replied to the thread Raider got so Buzzed.It's not a Kia!
-
Where it promptly caught fire like its predecessors were so inclined to do.
-
Enki replied to the thread 2006 Mazdaspeed 6 bogging at boost.There's no photo on your post, but its a brass tube coming off the rail and connected to the HPFP via a hose with yellow/neon yellow...
-
_UsUrPeR_ replied to the thread 2006 Mazdaspeed 6 bogging at boost.I used engine oil. Liqui Moly 5W-30 to be specific. On the plus side, I have a whole second fuel rail from a failed engine. Is the red...
-
-
Enki replied to the thread Raider got so Buzzed.Where it promptly caught fire like its predecessors were so inclined to do.
-
Enki replied to the thread 2006 Mazdaspeed 6 bogging at boost.Correct; des is targeted, act is actual. At idle, it should be near 400 or so. When you assembed the HPFP internals, what did you use...
-
Raider replied to the thread Raider got so Buzzed.Well I did drive it home to your mom's house.
-
_UsUrPeR_ replied to the thread 2006 Mazdaspeed 6 bogging at boost.Hey thanks! I just installed a Corksport HPFP in July, and the vehicle was behaving semi-normally before this issue developed. Out of...
-
Log 36 shows you have low rail pressure; either the HPFP has issues or your PRV has issues. It's actually a bit on the high side for... -
Enki replied to the thread 2006 Mazdaspeed 6 bogging at boost.Log 36 shows you have low rail pressure; either the HPFP has issues or your PRV has issues. It's actually a bit on the high side for...
-
Kaden Kilber replied to the thread Maisonvi full size battery tray.Do you still have the file for this? I'm hoping to replicate it, and hole position measurements would make it much easier. -
gotovato replied to the thread Building for the road course...again.Track day yesterday. Was a charity time attack event with some very..sketchy classing lol. Finished P3 in class which is OK. I was on...
