Black Knobs

Maisonvi

Maisonvi

Grass-Roots Vendor
Platinum Member
Trying out a coating (Salt Bath Nitriding) on a knob Im doing for a friend. Did a couple I had lying around in it as well. This is not something I plan to offer on a regular basis as its quite expenisve, so I would need a lot of interest and make them in quantity.

Its a nice satin looking finish. Its largely used on firearms, so I expect it to hold up quite well. Hard to get a great picture of it.

But that said, I have 1 sphere, and 2 dessert beagles up for sale here. Sphere will be $75 shipped, and the DB will be $85.

MSO gets first dibs, I will post on the FB probably next week if they dont sell here.
20190524_152726.jpg
20190524_152737.jpg
20190524_152743.jpg
 
Last edited:
Have you considered using Duracoat or Cerakote? Since we're on the topic of firearm coatings that are strong.
 
Last edited:
Bigelow said:
Will this be even hotter in the summer than the standard?
Click to expand...

I doubt it wlll be any hotter than a stainless knob, (which can get wicked hot). But a drink coozie over it was always my solution.
[doublepost=1559138422][/doublepost]
alexwlwsn said:
Have you considered using Duracoat and Cerakote? Since we're on the topic of firearm coatings that are strong.
Click to expand...

Really any coating is an issue since I do such small quantities. Most have $150 minimum or more. so for a knob or 2 thats just not feasible
cost wise
 
Check out WMD guns for coatings. They do small parts in nitride at reasonable prices. I already have my custom sphere knob from you. I thought about having it cerakoted at one point.
 
What's the weight on those? How's the heft? Is that sphere a worthy black ball?

Sent from my meat puppet's electric box
 
You must log in or register to reply here.
Back
Top