Ground locations ?

J

Jesse joshua Garcilazo

Greenie N00B Member
ok guys i have a no start thread i did a few days back . problem is no fuel into cylinder. timing is good checked it , i have compression .i have fuel pressure (using ids i get 6.74 mpa cranking) injectors work tested outside they spray. i have spark. i reprogrammed ecu using ids nothing. i have all grounding points that i can find. my question is can any one name the ground locations in total so i can check if i got all of them ?

so far
1: hpfp ground (even extended to negative )
2: one ground on harness on top of trans
3: two on front of trans ( one fat one and one small one) (also extended to negative terminal)
4: passenger motor mount
5: driver fender area that goes to negative terminal aswell

am i missing any other grounds ?
my only problem is i am not having fuel spray into cylinders
i reprogrammed Ecu using ids
parameter reset for PATS
new cam and crank sensor
new maf
new Fuel rail sensor
 
Awafrican said:
Seems like this would be a good update to that thread....
Edit: have to looked at the shop manual at all? I ask because I have not
Click to expand...
i have looked at manual but have not found locations points . i have ecu pinouts but i want harness ground locations and see if im missing one because as i go to search forums i found another thread saying there is two ground on top of trans and two in front . i only have one on top and two in front . which is why i ask for the locations
 
i did mention other threads (i meant that one specifically ) it states two grounds on top of transmission . where ?! i only have one . i need more people to confirm
 
Jesse joshua Garcilazo said:
ok guys i have a no start thread i did a few days back . problem is no fuel into cylinder. timing is good checked it , i have compression .i have fuel pressure (using ids i get 6.74 mpa cranking) injectors work tested outside they spray. i have spark. i reprogrammed ecu using ids nothing. i have all grounding points that i can find. my question is can any one name the ground locations in total so i can check if i got all of them ?

so far
1: hpfp ground (even extended to negative )
2: one ground on harness on top of trans
3: two on front of trans ( one fat one and one small one) (also extended to negative terminal)
4: passenger motor mount
5: driver fender area that goes to negative terminal aswell

am i missing any other grounds ?
my only problem is i am not having fuel spray into cylinders
i reprogrammed Ecu using ids
parameter reset for PATS
new cam and crank sensor
new maf
new Fuel rail sensor
Click to expand...

Have you properly aligned crank sensor at tdc?
 
You must log in or register to reply here.
Back
Top