Speed6 crank but no start

N

Nick Ferreira

Greenie N00B Member
Hi there I just swapped a gen2 block with a speed6 head into my speed 6 and got everything back together in the car the car cranks over but doesn’t try and fire at all after a couple cranks the fuel feed from the fire wall to the hpfp starts to leak as there is so much pressure in the line I tried checking for spark as well and no spark any ideas?
 
Your fuel line isn't leaking because of so much pressure it's leaking because it's either cracked and broken or it's not sealing on the connections again could be a broken connection.

Have you gone over all your connections and grounds? Especially the ground on the hpfp ground and passenger motor mount
 
I have the grounds all hooked up as well as the line hooked up properly ,, the fuel line won’t leak for a couple of cranks but then eventually starts leaking I’m wondering as well if I should try putting a wire from the battery ground to the hpfp ground to check for spark?
Fuel makes it to the hpfp but doesn’t seem to get to the motor
 
It leaked from one part of the line where the 2 lines connect then I fixed it with a hose clamp but then it moved towards another part of the line

If there’s any ideas or solutions please let me know I’m stuck on this and am trying to get it up and running again
 
Last edited by a moderator:
Can you post a photo of specifically where you mean the leak was coming from originally and then where it moved to? Your description is a little unclear.
 
You must log in or register to reply here.
Back
Top