Post a Photo of your Car as it Sits Right now!

[Raider]

Same @gotovato . Same.

 

[StreetSpeed6]

I feel you guys.... I'm just diving into my vvt job...

 

[DualSpeed]

Here's mine!

 

[StreetSpeed6]

Here's mine!View attachment 17219

Be thankful it's getting the vvt out of the car not in it haha It is not a fun job really...

 

[DualSpeed]

Be thankful it's getting the vvt out of the car not in it haha It is not a fun job really...

Ya, I can only imagine!! I pulled the whole thing, because I was having clutch/trans issues. Good thing I did, this is what I found.

 

[Chef]

Sitting pretty in my neighbors garage for the winter.

 

[StreetSpeed6]

Ya, I can only imagine!! I pulled the whole thing, because I was having clutch/trans issues. Good thing I did, this is what I found. View attachment 17221

Dang man! Yeah definitely glad you pulled it then and hope it all goes back together smooth and what not for ya

 

[Cfoldone]

S3 install was completed. Just in time. Only 1/2 hr run time since, because this snow was predicted. So wanted done before snow. Rain later in the week though.

 

[iamareios]

Does this count? Lol

sent from tapioca

 

[StreetSpeed6]

Does this count? Lol

sent from tapioca

This here folks is an extreme case of good ol' detonation! Lol

 

[dudemancool1904]

Winter spec lol

 

[macdiesel]

Full busticated.

 

[ToyCop]

Cleaned it up a bit. I need to do quite a bit of paint correction when my new pads and cream come in.

 

[_Mazdarati]

 

[Cfoldone]

Something about a finish that is...so fantastic...and the Radium PVC plate gets a clean home...amazing parts washers too. The beginnings of good things to come.

 

[bzwyatt]

I have a CX-7 but I'm crashing your thread anyway.

 

[StreetSpeed6]

Something about a finish that is...so fantastic...and the Radium PVC plate gets a clean home...amazing parts washers too. The beginnings of good things to come.View attachment 19719 View attachment 19720 View attachment 19721 View attachment 19722

Is that cross-hatch in the cylinders?

 

[Cfoldone]

Yes. Looks like 45 but was so fine on repasses can't really see last stroke of hone stones. As explained by machinist.. a sunnen fully digital automatic bore/hone bar head and cnc control of stroke of axis. Supposed to be better than oem, better ring break in + longevity. Awaiting bore gauges to measure and double check. Was nice to have bore edge chamfered correctly too. No fist shaving as I checked bore cleanliness.

 

[StreetSpeed6]

Yes. Looks like 45 but was so fine on repasses can't really see last stroke of hone stones. As explained by machinist.. a sunnen fully digital automatic bore/hone bar head and cnc control of stroke of axis. Supposed to be better than oem, better ring break in + longevity. Awaiting bore gauges to measure and double check. Was nice to have bore edge chamfered correctly too. No fist shaving as I checked bore cleanliness.

Sounds like a legit piece of machinery lol My engine builder has zero things fancy or new really but they build solid race engines for dirt track cars. Needless to say I kind of wish I had more solid knowledge of exactly everything done to my motor. I know just not exact specs type stuff basically. I feel like my motor takes more boost to make the power it should idk..

 

[MacheteJames]