Rebuild Rear Caliper - Mazda 3, Mazda 5 or Mazdaspeed

Speedhunter

Speedhunter

Greenie N00B Member
I just bought 2 rear caliper from a MAZDA 5 for a bigger setup in the rear for my MS3.

I try to rebuild them completly with everything new and a powdercoating for a fresh look. I tearing a part the caliper but right now I'm stuck to remove the ebrake actuator ... there is a cclip inside (don't see it) or I remove the spring for the ebrake but there is a stopper to remove the actuator from the caliper. Do I need to remove all this to clean everything they seem to be dirty inside just want to be sure I clean everything and change all the seal possible. This way I will have a free problem rear caliper for some years.

I find some MX5 or FD RX-7 how to ... but doesn't look exactly like our rear caliper

Thanks for your help
 
yep sir ! know that. Just try to find a "how to" to completly strip the rear caliper for a complete rebuild ... is it possible to remove the ebrake actuator ... completly remove all parts to touch every part of it and rebuild like new
 
Last edited:
Does it has a cclip inside the rear caliper to retain the bolt inside on what the piston thread in ? how I suppose to remove this shaft from the caliper

How I suppose to remove the ebrake lever ?
 
You must log in or register to reply here.
Back
Top