60-100 times

VersaTuned - Selftuned- 07 Mazdaspeed3 - 93 PumpGas - EFB BOV, Ebay DP, CNT CatBack, CorkSport Turbo, HTP 3.5 Intake, Turbo XS FMIC, Drag 48 17x9 +38, 245/40 17 -Hankook Ventus V12 evo 2

4th gear - 60-100 5.5s - adjusted for tire size 63-103 mph
4th gear - 60-100 5.3s - not adjusted

Also, not sure how accurate the current vdyno 1.01 settings are.
j0y6ocV.jpg
 

Attachments

Last edited:
  • Like
Reactions: Sho
mangosmoothie said:
but we'd need to start in 3rd and shift to 4th for a true comparison on that site.
Click to expand...

When I was stock turbo or even GT3076r a straight 4th gear pull generally got me better 60-100 times than a 3-4. With my 6062 though I can cut almost a second or so off if I shift from 3-4 rather than just pulling straight through 4th.
 
  • Like
Reactions: Sho
PD Tuned, CS turbo, 3" intake, 3" catless CBE, Cobb FMIC, EFB 50/50 BOV, RX8s with mismatched tires. E30 mix.

5.222s. Pulled a 5.05 today, as well, but I'm going to graciously omit that one since I suspect a slight downhill assist.

Note: tire size adjustment means my 60-100 is actually 59-99 on the speedo. I averaged the 58mph/60mph cells and the three 99mph cells, and split the difference between those numbers.
1.01.jpg
1.09.jpg
 

Attachments

Last edited:
Down to 4s flat. I won't declare it official until I'm officially done tuning but that one is on the table.
 
mangosmoothie said:
@VoodooJef you have any new 60-100 logs? :)
Click to expand...

I might be (barely) sub 4 seconds now but wheelspin has been an issue. Maybe once we have some warm weather last long enough to actually warm up the roads I can see where I`m at but right now as soon as I`m at about 75mph it`ll boil the tires at WOT. Too cold for traction.
 
Looks like everyone here is past strictly bolt ons. Curious what fully bolted speed will do.
 
My speed was bolt ons. Stock downpipe, test pipe, intake. Also had a tmic and cbe but they didnt do much, especially on e33 fuel mix.

~6 is a good expectation for most weather and fuels. I clocked 5.7 in ideal conditions

If you ran a catless dp and a 3 bar map sensor to run a little more boost, the numbers might drop closer to mid 5's.
 
3.89

550whp/500wtq

CPE TMIC, E54, Speed Solutions TMIC 6th Port setup, Speed Solutions built motor, head work, CS cams, EFR 7163, Loudvalves Exhaust Cutout, ButtStallion 3.5" intake, CS intake manifold, lots of other things.


Also how about we order this goddamn list by times or something? Shit's hard to read. You can put this one up on top :) TMICs suck.
 

Attachments

You must log in or register to reply here.
Back
Top